Gas Tank Filler Adapter and Fuel Filler kit.Tall Screw On. Part # GTA200k “Tall” This Adapter is used with fuel filler to eliminate hose and hose clamps when installing a bed mounted gas tank. This adapter allows for the gas tank to sit higher in the frame rails raising the gas tank ground clearance. This is a screw on unit. Simply locate the desired area of your fuel filler and using a 1 ¾ hole saw drill the top of the tank where desired fill neck should be. Insure that there are no intrusions like splash shields in the area of the desired location. Align the adapter with the 1 ¾ hole. Drill and mount the adapter with gasket and 6 securing screws. Now you can align your fuel filler neck to this adapter using the hardware included. NOTE: Extreme caution should be taken when drilling gas tanks to avoid explosions if sparks should occur. NOTE: Not recommended for any application if a gas tank has had fuel applied to it at any time. NOTE: Adapter should be used with new gas tank that has not had fuel in it to prevent possible hazards.